GameSir on PlayStation

Needs Zen Link or the A1 bypass in A1 (zen-link-setup, ps5), plus Zen Studio Live to check the controller mode.

G7 Pro

1. Connect the controller to the Zen with the GameSir dongle (back switch toward LT) or the cable (back switch in the middle).
2. Set the polling rate to 250 Hz. 1000 Hz can work, but go back to 250 Hz if anything misbehaves.
3. Hold Share + Menu until the controller changes mode.
4. In Zen Studio Live, open Device Monitor and check the left side shows Xbox One inputs. Do not carry on until it does.
5. Set Output Protocol to Auto in Zen Studio Live.

G7 8K

1. Connect the controller to the Zen with the GameSir cable or dongle.
2. Set the polling rate to 250 Hz. 1000 Hz can work, but go back to 250 Hz if anything misbehaves.
3. Hold View + Menu until it switches to PC (XInput) mode. The light flashes while it changes.
4. In Zen Studio Live, open Device Monitor and check the left side shows Xbox One inputs. Do not carry on until it does.
5. Set Output Protocol to Auto in Zen Studio Live.

• Green or white light: PC (XInput), the mode you need
• Red light: Switch
• Blue light: Android or PlayStation (DS4)

Tarantula 8K

1. Connect the controller to the Zen with the GameSir cable or dongle.
2. Set the polling rate to 250 Hz or 1000 Hz. Use 250 Hz if 1000 Hz gives trouble.
3. Hold Home + X until it switches to Xbox mode.
4. In Zen Studio Live, open Device Monitor and check it shows Xbox One inputs. Do not carry on until it does.
5. Set Output Protocol to Auto in Zen Studio Live.